Handmade swinging clown

Handmade materials: thin iron, thick wire, blown paper, rivets, screws, plastic bends, small iron bullets, brushes, paint, tape.

Production steps:

1. Do "swing boat ". According to the size shown in Figure 1, two curved pieces are made of thin iron sheets, and then a thin piece of iron is used as a connecting piece to connect the two curved pieces into one body, which becomes a "boating".

2. Make a bracket. According to the size shown in Figure 2, the bracket is finished with thick iron wire, and then a thin wire is used for the vertical line. One end is hung with a screw for hanging, the other end is attached to the bracket, and then the bracket is riveted to the connecting piece with a rivet.

3. Be a "clown". Cut a clown model with blown paper, draw the facial features and costumes, stick it on the "swing ship", then subtract a half of the plastic bend into a curved groove, tape it to the "clown" hand, in the groove Put a small iron bullet inside, so that the fun "clown" swing board is ready.